Combined T and Crossover for 60mm Galvanised Pipe Post Mould The 123 D48 is a

The 123 D48 is a Variable 40 degree to 70 degree angle joint

This fitting may also be used without the small return part to secure certain other types of sheet material to tubes eg

which is useful for awkward applications where angles cannot be accommodated by adjustable angle fittings

and vertical galvanised pipe of an outside diameter of approximately 42mm

Please note : This leg is square tapered evenly on all 4 sides

Combined T and Crossover for 60mm Galvanised Pipe Post Mould The 123 D48 is aWhere would you normally use this galvanised pipe fitting? The 165 Combined Tee & Crossover B34 is often used in racking and similar structures. This fitting allows both uprights and front and rear horizontal rails to be continuous. It is usually preferable for the upright to be on the outside of the structure (as per the photo) for maximum stability. The through tubes cannot be joined within the fitting. What size pipe does it fit to? This fitting