Pay in 4 interest-free payments of $25.79 Learn more
Ships within 48 hours · Estimated delivery Aug 15 - Aug 20
Once the desired angle is obtained
with an angle of 27 degree
It measures 1090mm in height
A generous spraying on the newly exposed section of timber is recommended
This fitting will work with horizontal galvanised pipe (tube) of an outside diameter of approximately 34mm
Sloping Floor Flange (30-45 degrees) for 42mm Galv Pipe D5VD02 Once the desired angle isWhere would you normally use this galvanised pipe fitting? The 251 Slope Base Flange (30 degree to 45 degree) is a base flange for sloping sites, adjustable from 30 degree to 45 degree. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright
US$ 28.00
US$ 55.99
US$ 21.52
US$ 610.64
US$ 26.00
US$ 37.38
